North Dakota Rules and Wiring Standards

Aluminum conductors in sizes smaller than no. ______ shall not be used.

A minimum of ________ 20-amp small appliance branch circuits shall be installed for counter receptacles in kitchens that are used to serve public gatherings at schools, churches, lodges, and similar buildings.

In dwelling occupancies, one 20-amp bathroom circuit for receptacles shall not feed more than _______ bathrooms.

A one hundred ampere main house panel must be installed using ungrounded conductors sized for the proper ampacity. The panel must contain provisions for a minimum of ________________ full-sized branch circuit spaces.

Service and feeder calculation for electric heating loads must be sized to _________ percent of the full load rating.

Exterior overcurrent devices must be located at a height of no less than ___________ feet above grade level to the bottom of the enclosure.

Exception: If raising the switch would exceed the height requirements of NEC 240.24(A).

One of the places switchboards and panelboards specifically may not be located is a:

Electric metallic tubing shall not be used in concrete ________ grade, in concrete slab or masonry in direct contact with earth.

____________ conduit shall not be installed in contact with earth or embedded in concrete.

One of the occupancies where metal raceways or metal clad cable (type MC) rated for the environment shall be installed is: